4
Configure Your Display Unit
6
You will now configure your Display Unit so it will be ready to provide you with real time
information as soon as you install your Sensor Unit.
Important:
Your Display Unit has three buttons you will use during configuration:
the
▲
and
▼
buttons on the front of the unit, and the PROG/SYNC button on top. In the
configuration instructions that follow, “Enter” means pressing the
▲
and
▼
buttons
to select the appropriate value, then pressing PROG/SYNC to record the value in memory.
The next parameter will then automatically start flashing.
The Display Unit automatically exits Configuration Mode after one minute of inactivity,
saving whatever values you set up to that point. If you are interrupted before you have
finished entering all your values, return to Configuration Mode and press
PROG/SYNC
successively until you get to the value(s) you need to modify.
TOP
Set your billing mode, the internal clock and the meter’s Power Factor
NOTE: If your Display Unit displays SLEEP, briefly press any button before
proceeding with the steps below.
2. Enter the current hour of the day.
3. Enter the current minutes of the day.
4. Enter the clock format you wish to use. Pressing
▲
or
▼
toggles
between 12 hour and 24 hour time display format.
5. Enter the current day of the week.
6. Enter the temperature format you wish to use. Pressing
▲
or
▼
toggles between degrees Celsius and Fahrenheit.
7. Enter the Power Factor you wrote down in Step 4. If you have a
meter with dials and a spinning disk, this value is most likely 7.2.
If you have a meter with a digital readout, it is most likely 1.0.
8. The TIER billing mode indicator (Flat/Tiered
rate) is now flashing. Pressing
▲
or
▼
alternates
between TIER, 2-PEAK (time-based, two rates) and
3-PEAK(time-based, 3 rates). Enter the indicator
that corresponds to your billing mode
9. You will now enter your billing details. While still in Configuration
Mode, and referring to the numbers you wrote down in Step 5, set
up your Display Unit for your billing mode by following the instruc-
tions in the appropriate table under Step 7 - Set Your Billing Rates.
1. Press PROG/SYNC until the Display Unit beeps once (about 3 seconds) and enters
Configuration mode. The hours start flashing.
(4 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern