Blue Line Innovations PowerCost Monitor Bedienungsanleitung PDF herunterladen (Seite 12)

5.2. Electromechanical Meter

Electromechanical meters have dials on the

face and a spinning disk with a black mark.

The faster the disk spins, the higher your

electricity consumption.

5.2.1. Preparing Your Sensor Unit

Proceed as follows to prepare your Sensor Unit

for mounting on your electromechanical meter.

1. Pull the Sensor Arm latch upward to open it.

2. Extend the Sensor Arm to its full length by

pulling on it. If you accidentally pull it out

completely, push it back into the casing.

3. Close the latch.

5.2.2. Installing Your Sensor Unit

1. Adjust the sensor mounting strap by turning the adjustment screw several turns with

a flat head screwdriver until it is a little wider than the diameter of your meter dome.

2. Fit the Sensor Unit over your utility meter as shown below.

Ensure that the Sensor Arm is as close to the front of the

utility meter glass dome as possible.

3. Tighten the sensor strap adjustment

screw until snug.The Sensor Unit

should still be able to move so

adjustments can be made.

Do not over-tighten!

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Keine Kommentare

Blue Line Innovations PowerCost Monitor Bedienungsanleitung Seite 12